What matters most in the FAA router investigation?
- Router failure: Officials say a router may have flooded the FAA network with data during a copper-to-fiber communications upgrade.
- FBI investigation: The FBI reportedly took the router into custody and plans to reproduce the incident.
- Flight grounding: The network problem was linked to Friday’s four-hour grounding of flights.
- Unresolved cause: Officials and L3Harris have not established whether the outage resulted from faulty equipment, contractor work or another cause.
The FAA router investigation follows Friday’s four-hour flight grounding, which Transportation Secretary Sean Duffy attributed to a router malfunction during a switch from copper wiring to fiber. This report explains what officials say happened, what the FBI plans to test and what remains unknown.
The suspected router failure disrupted the FAA network during a communications upgrade.
According to CNN, the FBI located the router and took it into custody for examination.
Early reports identified the router as newly installed equipment at South Arkansas Regional Airport in El Dorado, housed in a small radio site. In this city’s name, “Dorado” rhymes with “potato.”
In a CNN segment, Senior Justice Correspondent Evan Pérez said that anonymous sources had told correspondent Pete Muntean the router flooded the network with data. The sources characterized the incident as “a DDOS attack that the FAA did on itself.”
Pérez said the FBI plans to try to reproduce the incident and observe what happens, in an effort to determine what went wrong on Friday.
Reproducing the incident could help investigators examine how the router affected the network.
The FBI’s planned test focuses on whether the same network behavior can be triggered again.
Duffy said the data flood caused “over 1,000 connection attempts every four to five seconds” and said he did not “believe” a cyberattack caused the problem. He also raised questions about whether the cause was the router or the work of government contractor L3Harris, including the possibility of contractor error or faulty equipment.
In a statement provided to Gizmodo on Saturday, L3Harris said it had completed more than 70% of the planned conversion of airspace communications from legacy copper wires to a fiber optic system. The company said it took the grounding seriously and was working with the FAA on the investigation.
Critics of Duffy said the timing of the wiring change could be questioned if the upgrade was the root cause, because it took place during the day on a Friday rather than during a less busy period.
Upgrade timing was a point of criticism, while the cause of the failure remained under investigation.
The reported timing of the work does not by itself establish what caused the outage.
Homeland Security Secretary Markwayne Mullin, meanwhile, blamed Congress, describing the U.S. air traffic control system as “outdated” and saying it “hasn’t been a priority for Congress. And so this is what happens when Congress kicks the can down the road.”
What caused the FAA flight grounding?
Officials linked the grounding to a suspected router problem during the FAA’s copper-to-fiber communications conversion. Investigators had not established the precise cause in the reports described here.
The reported FAA outage involved a router, a communications network and an ongoing infrastructure upgrade.
What is the FBI doing with the router?
The FBI reportedly took the router into custody and plans to try to reproduce the network disruption. The test is intended to help investigators understand what went wrong.
The FBI’s reported investigation includes examining the router and attempting to replicate the incident.
How many connection attempts did Duffy report?
Duffy said the data flood generated more than 1,000 connection attempts every four to five seconds. He said he did not believe a cyberattack caused the incident.
Duffy’s reported figure was over 1,000 connection attempts every four to five seconds.
What did L3Harris say about the communications upgrade?
L3Harris said it had completed more than 70% of the planned conversion from legacy copper wires to a fiber optic system. The company also said it was working with the FAA to investigate the grounding.
L3Harris described the work as a copper-to-fiber conversion that was more than 70% complete.









